![]() I prefer to print with colorless plastic when accuracy and strength are needed, I noticed that colored plastic does not always behave predictably.Raod show - 'A LOT can - but only a LITTLE needs to' Therefore, I cannot show you how this edge router base works.īut I made a short review film on the finished product:ĭo not rush to chamfer and process the part after printing! Let cool for 6 hours! Yes, yes, yes - the part will become smaller by 1, or even 2 tenths of a millimeter (depending on the plastic - but my FDPlast PLA decreases by 0.1 mm in only 3-6 hours. ![]() Now it's very cold in Russia, bears walk the streets, and the blood runs cold in my veins. In the last picture I show how the puck looks BEFORE and AFTER processing. This way it will be easier to glue them, the washers should not protrude above the surface of the model. I recommend removing these burrs with a needle file or running a washer a few times over the sandpaper. ![]() Washers are punched at the factory and therefore have a burred edge on one side. (you can combine - I collected 4 magnets of 1 mm in one = a total of 12 magnets for three sections) (for the most other extensions from 2 mm to 20 mm).īase magnets: 8 mm in diameter, 4 mm thick Ordinary washers for 4mm screws: diameter 9mm thickness 0.8mm Ordinary washers for 3mm screws: diameter 7mm thickness 0.7mm (for the thinnest expansion 1mm).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |